Stainless-works Jeep Grand Cherokee SRT8 2012-14 Headers Manuel d'utilisateur télécharger pdf

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183

INSTALLATION INSTRUCTIONS FOR 2012+ JEEP SRT8

HEADERS

Thanks for purchasing Stainless Works Muscleflow Headers for your 2012+ Jeep Grand

Cherokee SRT8. We have gone to great pains to make sure that our exhaust systems fit

and sound great. Please follow these steps to ensure that your installation goes as

planned.

1. Stainless Works recommends the use of Hi-Temp RTV sensor safe silicon gasket

maker as an option to or in conjunction with the use of factory gaskets. The

recommended Oxygen Sensor Safe RTV is either Valco All-in-One Aluminum or

Permatex Copper P/N 101BR available at NAPA, Autozone and other retailers.

2. Disconnect the battery before starting work on the exhaust system for your

vehicle. Reconnect the battery when the job is completed.

3. Your exhaust system can be installed by a weekend warrior but the use of a lift is

recommended for ease of installation. If using a jack, the vehicle must be placed

on a level hard surface and jack stands are required for safety reasons.

4. You will assemble the components together as specified below, but only snug the

clamps as you move along from front to back. When placing the X-pipe into

position, make certain that you push it fully forward and level it in with the

vehicle. After aligning all the components in the vehicle, you will tighten all the

clamps working from front to back of the vehicle.

5. Remove air box and inlet.

6. Remove power distribution box from mount, then remove (3) 6mm nuts holding

mount in and remove (allows room to get to bolts).

7. Remove 6mm nut holding dipstick and remove.

8. Remove skid plate under transmission (4) 8mm bolts.

9. Remove all O2 sensors and 5/16 rubber hose (right side) from catted pipes.

1 2 3 4

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 INSTALLATION INSTRUCTIONS FOR 2012+ JEEP SRT8 HEADERS Thanks for purchasing Stainless Wor

Page 2

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 10. Disconnect exhaust from 2 bolt flanges with (4) 8mm spring loaded nuts. 11. Remove left

Page 3

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 29. Reinstall right and left cross member braces (6) 10mm bolts.

Page 4

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 34. Adjust and tighten front to back. 35. Be sure to have adequate

Pas de commentaire

Stainless-works Jeep Grand Cherokee SRT8 2012-14 Headers Manuel d'utilisateur